Home » Articles » How to Install Hardwood Floor Panels using the Nail Down method

How to Install Hardwood Floor Panels using the Nail Down method

There are many options for installing hardwood flooring. The most popular method of floor companies near me is the nail down. The nail down technique is the most simple and straightforward way to lay hardwood floors.

This method of installing hardwood flooring requires no special skills, unlike other methods that you need to be either a professional or amateur carpenter. That’s not the only thing you need. If you want to learn how hardwood floors are installed, you need to be persistent, patient, willing to do new things, and not give up. You must also be willing and able to follow all safety instructions.

You’ll Need Tools to Learn How Hardwood Floor Panels

Broom and dust pan – As you learn how to install hardwood floors, you will need to keep your hands clean.

Carpenter’s Crayon – This can be used to create guidelines for your sub floor. It can also be used for drawing lines to cut your hardwood panels.

Claw Hammer- Use your claw hammer to reach areas that are too close to walls or obstacles to swing a mallet.

Cutter Knife – This knife is used for any unforeseen tasks that may arise while installing hardwood floor. However, the main purpose is to remove excess wood when necessary adjustments of less than one millimeter.

An electric drill and a 332″ drill bit are used to drill pilot holes. They should be slightly smaller in diameter and length than your nails. This will stop your flooring panels from cracking once you’ve nailed them.

Hardwood Flooring nails (2″) – These nails hold your floor in place.

Nailer- You have two options: a hammer or a pneumatic gun. Although it is more efficient and faster, the pneumatic nail gun can be difficult to calibrate so that nails don’t sink too deep into wood and cause damage to hardwood panels.

Rubber Mallet: This is your chance for frustration to be pounded out as you learn how hardwood floor installation works. To get the panels to fit together, you need to pound them lightly. Do not place them too far apart. Otherwise, your floor may have crevices. However, if you force them too tightly together, they can be damaged or pushed so far that they bow.

Circular Saw- You will need to cut your floor boards to fit at the corners of each row of boards. The room’s fixtures will also need to be cut.

Leave a comment

Your email address will not be published. Required fields are marked *